TRUFAST WALL APPLICATIONS
Exterior Insulation and Finish Systems (EIFS)
EIFS is a type of building cladding system that provides exterior walls with insulation, weather resistance, and an aesthetic finish. Typically consists of a layer of a foam insulation board attached to the exterior wall, a reinforced mesh, and a durable and decorative finish coat.
RECOMMENDED ATTACHMENT SOLUTIONS
Grip-Plate TubeSeal for Lath Attachment
- Designed to help seal blind fastener penetrations of your WRB and air-barrier when mechanically attaching lath over continuous insulation
- Available in multiple lengths for insulation nominal thickness
- Grip-Plate TubeSeal for Lath Attachment product page
Grip-Plate Lath & Plaster Washer
- 1-1/4” galvanized steel washers used for attaching lath, exterior gypsum sheathing, plaster or stucco
- Washers can be installed with shot-in pins or Grip-Deck screws
- Keyholes for bonding of basecoat / plaster
- Grip-Plate Lath & Plaster Washer product page
Grip-Plate Tab Washer
- 1-1/4” galvanized steel washers used for attaching lath, exterior gypsum sheathing, plaster or stucco
- Can be used for foam and wire lath attachment
- Tab washer has 4 tabs for pre-spotting and lath engagement
- Grip-Plate Tab Washer product page
Plasti-Grip PBLP2 Prong Washer
- 2” diameter washer with Grip-Deck screws attaches EPS or XPS foam in polymer based (PB) EIFS assemblies
- Labor-saving prong allows on the wall assembly
- EIFS system manufacturer approved
- Plasti-Grip PBLP2 Prong Washer product page
Plasti-Grip PMF (Plastic Masonry Fastener) Anchor
- 1-3/8” diameter washer head
- Molded plastic insulation fastener for masonry substrates
- Permanently attach insulation to masonry, block, brick, or stone
- Simple to install – drill and hammer
- Plasti-Grip PMF product page